White95’s ‘23 F-150 “Abominable”

[weendoggy]

Not an earth shattering update but I switched rolling stock again. This round, I picked up some stock 21-23 17’s with pretty new tires from a buddy.

View attachment 37779

Bolted them up after work, used Forscan to adjust the speedometer and.. yeah. Here we are.

Before:

View attachment 37780

These were screwed in 22k miles for some reason.

View attachment 37781


After! I can dig it and they’re 30.5” instead of 31.6” so maybe it’ll 60’ better LOL

View attachment 37783

View attachment 37782

Not bad. Still looks stock and I saved 400-500 not buying new tires.

The two on the right have lots of wear showing either toe or camber. Were those on the front? -or- maybe you just like lots of camber

 

[white95]

The two on the right have lots of wear showing either toe or camber. Were those on the front? -or- maybe you just like lots of camber

See what had happened was...

Back when I lowered the truck, or shall I say attempted to lower the truck, the toe angle changed. I had it aligned after but apparently, those guys leave a lot to be desired. Didn't notice it quick enough and you see the results.

 

[white95]

Genius move!

Do the tires get any tread wear from all the hard launching?

They do spin some off the line but it's not excessive.

Not remembering to put it in 4wd and then launching drastically reduces tread life lol

 

[joemomma]

"Set the toe and let her go"

 

[white95]

Purchased VasFab front coil over mounts to be one step closer to properly lowering this beast.